yield point
英 [jiːld pɔɪnt]
美 [jiːld pɔɪnt]
屈服（流动，软化）点
双语例句
- Manufacture and Application of Low Yield Point Steel Used For Earthquake Resistant
建筑抗震用低屈服点钢厚板的生产与应用 - When the stress reaches the yield point, a large increase in strain occurs with no increase in stress.
当应力达到屈服点，应变会急剧增大而应力保持不变。 - The conventional photoelastic modes and procedures suffice to indicate whether or not the yield point of the material of the prototype will be exceeded.
常用的光弹性模型和方法能够指明原型材料的屈服点是否将被超过。 - Elastic limit, Yeung's module of elasticity to yield point
弹性限度、阳氏弹性系数及屈服点 - Properties of Low Yield Point Steels Used for Earthquake Resistant Buildings
建筑抗震阻尼器用低屈服强度钢的性能 - The Experimental Analysis of The True Yield Point of Metal s Bend and Tuist; This firm specializes in the production of bottoms for footwear for both men and women in thermoplastic and leather materials.
金属材料弯曲和扭转真实流动极限的实验研究该司专业生产男、装鞋大底，所选材质为热塑性塑料，及真皮材料。 - Beyond the yield point, the material will continue to deform, but with less stress than before, because the material has begun to yield.
超过屈服点之后，材料会继续变形，但是因为材料开始屈服，应力会减小。 - It was observed that the lower yield point was subject to a greater degree of scatter than that of the upper yield point.
业已观察到下屈服点比上屈服点易产生更大的散布度。 - The chemical components and microstructure are analyzed for the hot-rolled reinforced bar, of which the yield point is not so clear, some measures proposed.
对存在屈服点不明显问题的热轧带肋钢筋的化学成分和组织进行了分析，提出了改进措施。 - The straight-line portion of the diagram up to almost the yield point is known as the elastic region of the diagram.
从图表中的直线开始上升一直到屈服极限点是弹性变形区域。 - Lacking stiffness and giving way to pressure. elastic limit, Yeung's module of elasticity to yield point
缺少硬度而且容易向压力屈服。弹性限度、阳氏弹性系数及屈服点 - Although there is no yield point, one needs to be defined.
虽然没有屈服点，我们必须明确。 - Cause analysis of unobvious yield point of low carbon steel hot-rolled wire rod
低碳钢热轧盘条屈服点不明显的原因分析 - When the material does not display a yield point, a quantity known as the proof stress is used when making design calculations.
当材料不显示屈服点时，在进行设计计算中，往往使用所谓弹性极限这一数值。 - The yield point represents the dividing line or transition from the elastic to the plastic region of the curve.
屈服点是弹性变形区域到塑性变形区域之间曲线的过渡点。 - The stress strain curves displayed the characteristics of low yield point, continuous yield and no obvious yield point.
结果表明：其应力&应变曲线表现出屈服点低、连续屈服、没有明显的屈服点等特性； - Isotropic steel sheet with low Δ r and low earing index was taken to study the effect of temper-rolling on the yield point elongation, r value and Δ r.
以Δr和制耳指数较低的各向同性钢为研究对象，探讨了平整对各向同性钢板屈服延伸、r值及Δr的影响规律。 - The yield point and apparent viscosity of this suspension sharply increase with the temperature.
屈服值、表观粘度均随温度升高而剧增。 - The main factors effecting on reliability of bolted joints, the conditions of increasing the reliability of tightening method up to the yield point, and the scope of application are proposed by the authors.
文中还提出了影响螺栓连接可靠性的主要因素以及提高屈服点拧紧法可靠度的条件与使用范围。 - The yield point, quality grade and deoxidation are used to express the brands of steels, which reflects the features of engineering structural steels. The new standards are also favorable for technical exchange internationally for China's products to enter international market.
钢的牌号表示方法改为用屈服点、质量等级、脱氧程度表示，反映了工程结构钢的特点，便于使用选材.新标准与国际接轨，便于与国际进行技术交流和我国产品进入国际市场。 - Lower stress sensitivity and lower yield point temperature were found after cold hardening.
发现胁强敏感度和屈服点温度受冷锻炼影响而下降，时间敏感度未表现明显变化。 - Meanwhile, parameter p ( the ratio of yield process), parameter ε ( ductile interval coefficient), and imaginary yield point elongation are presented and applied in engineering design.
同时，提出了屈服过程比P，延性区间系数着，以及假想屈服平台的概念，并且尝试应用于工程设计中。 - Besides, the dynamic yield point history of materials during impact is discussed based upon Taylor's momentum model.
在Taylor模型基础上，讨论了在加载过程中材料动屈服限值随时间的变化历史。 - The lower yield point and Luders band disappear when the hydrogen content exceeds 18.7cm~ 3/ 100g.
在氢含量高于18.7cm~3/100g以上时，下屈服点和Lüders带消失。 - Relationship between advancement in age and Casson viscosity and Casson yield point stress
年龄与Casson粘度和Casson屈服值的关系 - The primary methods for controlling thread tightening consist of torque application, torque-angle rotation and yield point.
用于控制螺纹拧紧的方法主要有扭矩法，扭矩&转角法，屈服点法三种。 - For the structure system without obvious yield point Δ Y, we determine its ductile coefficient by adopting the method of simulation yield process.
对于没有明显屈服点ΔY的结构体系（或材料），可以采用模拟屈服过程法确定其延性系数。 - The vascular bundle fracture was brittle fracture; there was no obvious yield point and plastic deformation.
毛竹维管束的断裂属于脆性断裂，没有明显的屈服点和塑性变形。 - A yield point is included in the load-displacement curves of middle cross section of the composite truss.
桁架中截面载荷-位移曲线的屈服点可用于表征桁架的结构刚度和屈服载荷。 - Comparing composite materials configuration of the drilling fluid with the slurry, the yield point and viscosity were decreased significantly.
复合材料配置的钻井液与基浆相比，切力和黏度明显的降低。